District XI—Alaska, Idaho, Montana, Oregon, Washington

Chuck Bower
Vice President
cbower@whidbey.com
6075 S. Coles Rd., Langley WA 98260
Tel.: (360) 632-9211; www.amadistrict-xi.org
The following report comes from District XI Associate Vice President Mike Mosbrooker.
At some point in the mid-1990s, the Skagit County RC Club in Washington initiated a weight-lifting contest for model aircraft. Carlton Molesworth wrote about this effort in a Model Aviation article in April 1996.
The rules for the contest were simple. The aircraft must be powered by an unmodified O.S. 40FP engine; must fly for a minimum of one minute; must fly from the Skagit Club grass field; must land without damage; and must fly both with and without payload. The airplane carrying the greatest payload wins. The Whidbey Island RC Society (WIRCS) designed and built an aircraft called Aardvark. It had a 16-foot wing, lifted more than 26 pounds, and is now in the National Model Aviation Museum.
This year, WIRCS held the contest again, but with a much smaller motor, expecting to result in aircraft approximately 25% the size of the original contest winner. The specified motor was a Great Planes RimFire 400 with battery and other equipment selection up to the contestants. Record flights were to be flown September 19, 2015.
The day dawned with rain and a breeze. By the time of the record flights, the rain stopped, but the breeze increased to winds at 9 mph with gusts in the teens. Not ideal. Only two aircraft dared brave the elements. One was designed and built by Dan Simenson and the second by Bob Harper and Chuck Bower. Interestingly,

both models were roughly the same size with approximately 5-foot wings. Dan’s airplane was constructed of foam board, foam, and balsa, while Chuck and Bob used balsa and lightweight Mylar covering.
Each record attempt would require one empty and one payload flight. Because of the wind, the rules were modified to require only one flight without weight and both airplanes managed to do this.
Dan flew his Mini Grunt with 40 ounces, but for less than a minute. He tried again with 36 ounces and broke the nose on landing. He repaired the nose and tried again with a similar result. Chuck and Bob tried to lift 40 ounces with their Bob-N-Chuck. It flew pretty well, but the wind caught it when they attempted to land. The damage was such that no further attempts were made. Because no entry made a qualifying record flight, but both did get 40 ounces off the ground, the result was called a draw.
Testing has already started to improve the performance for next year’s flight.

Bob built a motor test stand used to determine thrust, amp draw, volts, and mAh used per minute. The simple 90° lever pushes down on the digital scale to measure the static thrust of several propeller choices.
AMA Expo 2016 takes place January 8-10 at the Ontario Convention Center in Ontario, California. There will be a joint District X and XI meeting held on Saturday, January 9, at 1 p.m.
Performance R/C Hobbies closed its doors after a long history of supplying its customers with all the parts for trains, cars, and airplanes. A large group of modelers came from miles around to show their appreciation. Suzy Thornton and Performance R/C Hobbies will be remembered as a great hobby shop in the Northwest in the years to come.

We all have our memories of those places where we could look at the engines, the kits, and all the little parts we could use to build our dreams. I spent my paper route money at May’s Five & Dime. There was a 4-foot glass case where the model airplane engines sat just out of my reach. There were kits on a shelf behind the case, covering and paints, and your favorite glue! I studied that case on Saturday mornings so I could tell Mrs. May just what I wanted.
The number of shops that have closed has grown throughout the years—Green Lake Hobbies, Queen Ann, Webster’s, and the Hobby Hive. These were just a few of those fond memories I have where modelers would gather. I hope this brings you memories of your favorite shops!
The North West Model Hobby Expo takes place January 29-31, 2016, at the Evergreen State Fairgrounds in Monroe, Washington. I hope to see you there at the District XI meeting!
Associate Vice Presidents: Darrell Anderson, Great Falls MT; d.l.anderson@bresnan.net; Bryan Batch, Spokane WA; bhobbies@qwestoffice.net; Del Herring, Wenatchee WA; del.herring301@gmail.com; Mike Mosbrooker, (360) 679-9139; mosbrookerdxi@comcast.net. Chris Rankin, Bend OR; (541) 593-3294; MissleMist@rocketmail.com; Robert Stephens, Anchorage AK; rfstephens@hotmail.com; Al Watson, Bellevue WA; alenawatson@msn.com; Bryan Wood, Boise ID; (208) 412-3254; bw5493@yahoo.com. Frequency Coordinator: Phil Tallman, Medical Lake WA; phillip.tallman@gmail.com. FF/CL Coordinator: Mike Hazel, P.O. Box 505, Lyons OR 97358; zzclspeed@aol.com. RC Coordinator: Dan Rood, 629 W. 26th Ave., Spokane WA 99203; drdantempo@yahoo.com. Webmaster: Chris Rankin.



