The Engine Shop 2003/05
BILL BROWN died on January 8, 2003. I’m not going to write an
obituary for him here. However, I do want to point out that Bill Brown
accomplished the same thing for model-airplane engines—not once,
but twice—that Thomas Edison did for electric light. Although neither
man made the original inventions, each of these creative geniuses was
the first to come up with practical-for-production versions that anyone
could use.
The Engine Shop - 2009/10
WITH THIS COLUMN, I’m beginning
my 13th year writing “The Engine Shop.”
In the past dozen years, I’ve tested and
reported on more than 100 new model
airplane engines and wrote about more than
twice that number of older types
The Engine Shop - 2004/03
I HAVE GOOD news for fans of highpowered
Radio Control (RC) engines: Rossis
are back! These superb Italian-made power
plants were off the market for a while, but
they’ve been available again since last
September, in a new Matrix model.
The Engine Shop - 2006/02
Luckily Eric Clutton (“Doctor Diesel” and PAW’s US
representative) was at the field too. He and I examined my PAW .06
thoroughly. We changed needles, looked for compression leaks, and
checked for sticky bearings. Everything seemed normal. Then Eric
removed the air intake tube (this is a nonthrottled engine) and solved
the mystery.
Secrets of Soldering - 2009/09
THIS ARTICLE WILL cover soft
soldering. That’s done with solders that
melt at relatively low temperatures—lower
than 500 degrees Fahrenheit

